Configuration Guide for Model Number: GMEV40CME1B-WC

Model: GMEV40CME1B-WC

• Power: 9.6 kW AC Level 2 charger, 240 Vac, 40 A
• Connectivity: Wi-Fi, Ethernet
  
  
  

Wi-Fi Setup:

1. Connect to Commissioning Tool:
   • Download and install the Eaton EV Charger Commissioning Tool here on a Windows 8/10/11 PC. The Software can be found  in Resources under Software, firmware, and applications. 
   • Use an RJ45 (Ethernet) cable to connect the EV charge station to your computer. The Ethernet port is located on the bottom surface of the charge station.
2. Configure Wi-Fi:
   • In the Commissioning Tool, navigate to Settings -> Wi-Fi.
   • Enter the SSID (Wi-Fi network name) and password of the Wi-Fi network.
     
   • Click Submit to send the credentials to the EV charge station.
   • Check the Activity Log in the tool to ensure the Wi-Fi credentials were successfully sent.
     
3. Reboot:
   • Reboot the EV charge station via the Commissioning Tool by selecting Other Functions -> Reboot EV Charge Station.
   • Disconnect the Ethernet cable after the reboot.
4. Verify Wi-Fi Connection:
   • When the station powers back up, it should automatically connect to the Wi-Fi network and the Eaton CNM.
   • On the LCD screen:
     • A Wi-Fi icon will appear, showing signal bars, indicating connection to the Wi-Fi router.
     • An Eaton CNM chain icon will also illuminate, confirming the station is connected to the Eaton CNM.

Ethernet Setup:

1. Connect Ethernet Cable:
   • Plug an Ethernet cable from the router directly into the charge station’s Ethernet port.
   • Ensure that the router has DHCP enabled to assign an IP address to the station.
2. Verify Ethernet Connection:
   • On the LCD screen:
     • A computer screen icon with a checkmark will appear, indicating a successful Ethernet connection.
     • The Eaton CNM chain icon will illuminate, showing the station is connected to Eaton CNM.